Specifying the 2in1 transmission setting, Specifying the 2in1 transmission setting -25 – Minolta Scanner Mode User Manual
Page 152
Performing an Internet Fax/IP Address FAX Operation
8
Scanner Mode
8-25
2
Select how to output the
report, and then touch
[Enter].
❍
To output the
transmission report in
method that has been
previously specified,
touch [Default]. Refer to
“Specifying Report
Output Settings” on
page 13-41.
❍
To output a transmission result report with every transmission,
touch [On].
❍
To output a transmission result report only if the transmission
failed, touch [If TX Fail].
❍
To stop the transmission result report from being outputted, touch
[Off].
Specifying the 2in1 transmission setting
➜
Touch [Set 1], and then
touch [2in1].
[2in1] is highlighted.