Multi-Tech Systems CDMA Wireless Modem - Manual (Page 81)

Chapter 11 – V24-V25 Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 81
Request Identification Information I
Description: This command causes the product to transmit one or more lines of information from the
DCE.
Syntax:
Command syntax: ATI
Command Possible Responses
ATI0
Note: Display manufacturer data MODEM
800 1900
OK
ATI3
Note: Display software revision data S/W VER: WISMOQ …
OK
ATI6
Note: Display capability data +CGSM, +CIS707, …
OK
Restore Factory Setting &F
Description: This command is used to restore the factory setting from NV memory. The settings that are
affected by this command are shown in Chapter 20. This command will reset the modem as
the very last part of its operation.
Syntax: Command syntax: AT&F
Command Possible Responses
AT&F OK
Note: Command valid, modem resets
Save Configuration &W
Description: This command writes the current configuration to NV. See table in Chapter 20 for a list of
items.
Syntax: Command syntax: AT&W
Command Possible Responses
AT&W OK
Note: Command valid