Multi-Tech Systems CDMA Wireless Modem - Manual (Page 157)

Chapter 19 – Qualcomm Defined AT Commands for CDMA Operation
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 157
Reset RLP 3 Protocol Statistics $QCRL3R
Description: This command is used to reset the RLP 3 protocol statistics.
Syntax: Command syntax: AT$QCRL3R
Command Possible Responses
AT$QCRL3R?
Note: Display the current setting ERROR
Note: Command is not valid
AT$QCRL3R
Note: Reset TCP statistics counter $QCRL3R:
OK
Note: Command is valid
SCRM’ing Selection $QCSCRM
Description: This command is used to enable or disable the mobile from SCRM’ing.
Values:
0 : Mobile never SCRMs.
1 : Mobile can SCRM as needed.
Note: Command only applies to SO 33 calls. This value is stored in NV. The default is 1.
Syntax:
Command syntax: AT$QCSCRM=
Command Possible Responses
AT$QCSCRM?
Note: Display the current setting $QCSCRM: 1
OK
Note: Command is valid
AT$QCSCRM =?
Note: Display the range of values $QCSCRM: (0-1)
OK
Note: Command is valid
AT$QCSCRM =0
Note: Set value to 0 OK
Note: Command is valid
R-SCH Selection $QCTRTL
Description: This command is used to enable or disable mobile R-SCH throttling.
Values:
0: Mobile never throttles R-SCH
1: Mobile can throttle R-SCH as needed.
Note: Command only applies to SO 33 calls. This value is stored in NV. The default is 1. For
MSM500, MSM5105, and MSM5100 ASICs only.
Syntax:
Command syntax: AT$QCTRTL=
Command Possible Responses
AT$QCTRTL?
Note: Display the current setting $QCTRTL: 1
OK
Note: Command is valid
AT$QCTRTL =?
Note: Display the range of values $QCTRTL: (0-1)
OK
Note: Command is valid
AT$QCTRTL =0
Note: Set value to 0 OK
Note: Command is valid