Multi-Tech Systems CDMA Wireless Modem - Manual (Page 150)

Chapter 19 – Qualcomm Defined AT Commands for CDMA Operation
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 150
C
HAPTER
19 - Q
UALCOMM
D
EFINED
AT C
OMMANDS FOR
CDMA O
PERATION
This section contains AT commands that are specified and developed by Qualcomm.
Note: Mobile IP related AT commands work only on the modems that supported the MIP features.
Transition to Diagnostics Monitor $QCDMG
Description: This command returns “OK” and then transitions the phone serial port to DM mode. DM
mode runs at 38.4 Kbps and uses a proprietary half-duplex protocol.
Syntax:
Command syntax: AT$QCDMG
Command Possible Responses
AT$QCDMG
Note: Transition to DM port OK
Note: Command is valid
Quick Net Connect $QCQNC
Description: This command is used to enable or disable the Quick Net Connect (QNC) feature.
Values:
0: Disable QNC capability. This means that packet Originations will use the Packet Data
Service Option number.
1: Enable QNC capability. This means that Packet Originations will use the Async Data
Service Option number.
Syntax:
Command syntax: AT$QCQNC=
Command Possible Responses
AT$QCQNC?
Note: Display the current setting $QCQNC: 0
OK
Note: Command is valid
AT$QCQNC=?
Note: Display the range of values $QCQNC: (0-1)
OK
Note: Command is valid
AT$QCQNC=1
Note: Enable QNC compatibility OK
Note: Command is valid