Multi-Tech Systems CDMA Wireless Modem - Manual (Page 171)

Chapter 21 – AT Command Examples
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 171
C
HAPTER
21 - AT C
OMMAND
E
XAMPLES
This chapter gives illustrative examples of general AT command usage.
Example 1: When the MS Has Already Been Powered On.
AT+CMEE=1 Enable the reporting of mobile equipment errors
OK
AT+CPAS
Get the MS Status
+CPAS: 0 MS is ready to receive commands
OK
Examples Where a Voice Call is Originated.
Example 3: When the MS is powered on.
AT+CMEE=1 Enable the reporting of mobile equipment errors
OK
ATD18001234567;
Make a voice call
OK ATD Command is being processed
+WORG:18001234567 Indication of call origination sent to the Base Station with dialing string 18001234567
+WCNT:3 Call Connected with CDMA Service Option 3, Traffic channel established.
Conversation…
ATH
Release the call
OK ATH Command is being processed
+WEND:10 Call Ended, end reason 10 (Normal Release).
Example with Incoming Calls
When the MS is Powered On.
AT+CMEE=1 Enable the reporting of mobile equipment errors
OK
AT+WIND=63
Ask to display the general indications.
OK
AT+CLIP=1
Enable the calling line identification presentation.
OK
AT+CNUM
Query own number.
+CNUM: “Phone”,”8585551212”,129
OK
Call the Number from Another MS.
+RING Incoming Call.
+CLIP: "8585551212",129 Identification of the remote party.
ATA Answer the call.
OK ATA Command is being processed.
+WANS Call has been answered.
+WCNT:3 Call Connected with CDMA Service Option 3, Traffic channel established.
…Conversation…
+WEND:6
Call Ended, end reason 6 (Normal Release), the call has been released by the remote party.