Multi-Tech Systems CDMA Wireless Modem - Manual (Page 65)

Chapter 8 – Short Messages Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 65
Select Broadcast Messages +CSCB
Description: This command turns on/off the reception of Broadcast SMS messages.
Values: The parameter of +CNMI command controls the indication of an incoming BC SMS
message .
:
0: Activates reception of BC SMS.
1: Turns off reception of BC SMS. Emergency BC SMS will be received in this mode.
Syntax: Command syntax: AT+CSCB=
Command Possible Responses
AT+CSCB=0
Note: Turn on reception of BC SMS OK
Note: BC SMS can be received
+CBMI: “BC”,5
Note: A BC SMS was received, and stored in slot 5
AT+CSCB=1
Note: Turn off reception of BC SMS OK
Note: Only Emergency BC SMS can be received.
Reception of all other BC SMS will be stopped.
Message Status Modification +WMSC
Description: This command is used to change the status of one message from preferred message
storage.
Values:
Location number of the stored message (integer)
new status to be stored, as for +CMGL command :
Text Mode
“UREAD”
“READ”
“USENT”
“SENT”
Possible responses:
OK Location is valid and has been changed
+CMS ERROR: 341 Non-volatile memory error
+CMS ERROR: 321 Invalid index (out of range or no SMS stored)
+CMS ERROR: 302 if attempting to change Status Report SMS or if syntax is
incorrect
Note: Status of SENT or USENT indicate changing MO memory SMS. Status of READ or
UREAD implies using preferred memory. Changes are not accepted when preferred memory
is set to Status Report (all status reports are always assumed to be READ and cannot be
changed).
Syntax:
Command syntax: AT+WMSC= ,
Command Possible Responses
AT+WMSC=4,”UREAD” OK
Note: Message stored in preferred memory index 4 status
changed to NOT READ
AT+WMSC=8,”USENT” +CMS ERROR: 321
Note: Invalid index, no message at location 8 of MO memory
AT+CPMS=”SR”
Note: Change preferred memory to Status
Report +CPMS:1,10,4,10
OK
AT+WMSC=0,”UREAD” +CMS ERROR: 302
Note: Cannot change Status Report messages