Removing the hinge support l and mp hold plate, Removing the battery connector ass’y, Removing the sc relay pcb and hdd hold plate – Matsushita CF-52AJYZDZM User Manual

Page 33: Removing the heat sink ass’y

9-10

9.1.23.

Removing the Hinge Support L and
MP Hold Plate

1. Peel off the three Tapes and remove the two Cables(Gray

and Blue).

2. Remove the six Screws , remove the Hinge Support

L and MP Hold Plate.

Screw : DRHM0093ZA

9.1.24.

Removing the Battery Connector
Ass’y

1. Remove the two Screws and , and remove

the Battery Connector Ass’y.

2. Remove the two Screws , and remove the Batt FPC

Plate.

3. Remove the two Screws , and remove the Batt Con

Holder from the FPC Batt.

Screw : DFHE5122YA
Screw : DRHM0093ZA

Screw : DRHM0112ZA
Screw : DRHM0115ZA

9.1.25.

Removing the SC RELAY PCB and
HDD Hold Plate

1. Disconnect the FFC from the Connector(CN6503).
2. Remove the two Screws , and remove the SC

RELAY PCB.

3. Remove the two Screws , and remove the HDD

Hold Plate.

Screw : DFHE5122YA
Screw : DRHM0093ZA

9.1.26.

Removing the Heat Sink Ass’y

1. Remove the Fan Duct.
2. Remove the four Screws , and remove the Heat

Sink Ass’y.

Screw : DRHM0119ZAT

Cables
(Gray and
Blue)

Tapes

Hinge

support L

MP hold

plate

Batt FPC plate

Batt con holder

FPC batt

CN6503

SC RELAY PCB

HDD hold plate

FFC

Tape

Fan duct

Heat sink

ass'y