Reviewing lcd messages (continued) – FARGO electronic HDP820 User Manual
Page 70

RESTRICTED USE ONLY
Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)
56
Reviewing LCD Messages (continued)
Message Cause
Solution
Realigning
Film
Indicates the Printer is aligning the
HDP Film to the proper position for
printing. Usually occurs after the
Printer has finished a print job.
No action required.
Smart Encode
Failed
The card's smart chip was not
encoded properly.
See the
Resolving the Failed
Smart Encode Error Message
procedure in Section 2, page 84.
Starting Self-
test
Indicates the self-test print is
preparing to print.
procedure in Section 2, page
132.
Temperature
Timeout
The Transfer Roller is unable to reach
the optimum temperature.
See
Resolving the Temperature
Timeout Error Message
procedure in Section 2, page 99.
Testing
Memory
Indicates the Printer's memory is
being tested.
See
in
Section 1, page 25.
Transfer
Cooling
The Printer's Transfer Roller is cooling
to the proper temperature.
procedure in
Section 2, page 97.
Transfer Lift
The Printer was unable to raise or
lower the transfer roller.
See
Resolving the Transfer Lift
Error Message
procedure in
Section 2, page 99.
Transfer
Timeout
The Printer was unable to complete
image transfer.
See
Transfer Process Errors
in
Section 2, page 91.
Continued on the next page