beautypg.com

Adjusting the image darkness – FARGO electronic HDP820 User Manual

Page 295

background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)

460

Adjusting the Image Darkness

Step Procedure

1

Choose MENU, Print Test Image and Gray/Align YMC to print a test card.

2

Examine the test card.

3

Select MENU, Setup Printer and Image Darkness.

4

Record the Image Darkness value on the test card last printed.

5

Enter a negative value to lighten the printed image.
OR

Input a positive value to darken the printed image. (Note: Be sure to make
adjustments in small increments of ± 4, to avoid over-adjusting this setting.)

Caution: The ribbon may jam or break if the setting is too high.

6

Press SELECT to save the value.

7

Print a test card as described in Step 1.

8

Repeat Steps 1 to 7 until the image darkness is correct.