FARGO electronic HDP820 - Manual (Page 65)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 51
Reviewing LCD Messages (continued)
Message Cause Solution
Card Jam:
Mag A card is jammed in the magnetic
encoding area of the Printer. See the Removing the Card jam in
the Printer’s Magnetic Encoding
Area
in Section 2, page 82.
Card Jam:
Smart A card is jammed in the smart card
encoding area of the Printer. See the Removing the Card jam in
the Printer’s Magnetic Encoding
Area
in Section 2, page 82.
Card Jam:
Transfer A card is jammed in the Transfer
Station of the Printer. See the Resolving the Card Jam
Error Message procedure in
Section 2, page 74.
Cards Low Indicates there is not an adequate
supply of cards in the Card Input
Hopper. Add cards to the input hopper and
press Resume to continue
printing.
Data Input The print data sent to the Printer is
corrupt or has been interrupted. See Communication Errors in
Section 2, page 60.
Data
Timeout The print data sent to the Printer is
corrupt or has been interrupted. See Communication Errors in
Section 2, page 60.
Door/Lever
Unlocked You are trying to print with the Front
Access Door open or the Release
Lever in the unlocked position. See the Resolving the Printer
Open Error Message procedure in
Section 2, page 90.
DRAM
Memory
Error The Printer's memory Module is bad
or not installed properly. See the Resolving the DRAM
Memory Error procedure in
Section 8, page 439.
EE
Checksum
Error Permanent circuit Board memory is
bad. See Resolving the EE Memory
Error procedure in Section 8, page
438.
Continued on the next page