beautypg.com

Adjusting the card guide rail (continued) – FARGO electronic HDP820 User Manual

Page 161

background image

RESTRICTED USE ONLY

Fargo Electronics, Inc.

HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0)

147

Adjusting the Card Guide Rail (continued)

Step Procedure

5

If the PolyGuard patch is being placed more toward a card's bottom edge (as
shown), move the Card Guide Rail slightly toward the front of the Printer
(opposite the direction you would like the patch to move).

6

Always make very slight adjustments to the Card Guide Rail and run a test print
after each adjustment until the optimum patch position is found. (Note: Be sure
the Card Guide Rail always remains parallel to the card path and that the screws
loosened in step 1 are retightened after each adjustment.)

Continued on the next page