FARGO electronic HDP820 - Manual (Page 130)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 116
Resolving the Ribbon wrinkle problems (continued)
Step Procedure
5 Check the Printhead and Printhead Mounting Bracket for debris and burrs.
6 Adjust Printhead Bracket Adjustment Screws. (Note: These can be found on the
backside of the Printhead. See drawing D840854).
a. Loosen and adjust the screws so there is equal Spring pressure on each side
of the print head.
b. Tighten the screws and reprint the card that is exhibiting the issue.