FARGO electronic HDP820 - Manual (Page 66)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP 800 Series Card Printer/Encoders Service Manual (Rev. 5.0) 52
Reviewing LCD Messages (continued)
Message Cause Solution
EE Memory
Error Permanent circuit Board memory is
bad. See the Resolving the EE
Checksum Error procedure in
Section 7, page 438.
Ejecting
Used Card The system Firmware has detected a
card already in the Printer and is
ejecting it. See Card Feeding Errors in
Section 2, page 65.
Film (lower)
Film (upper)
The HDP Film is not installed
properly or has run out, jammed,
broken or been damaged. If this appears as an error, see the
the
Resolving the Film Sensor
errors procedure in Section 2,
page 93.
Film Out The HDP Film has run out. Install
new Film and press RESUME to
continue. If this appears as an error, see the
the
Resolving the Film Sensor
errors procedure in Section 2,
page 93.
Film Sensing The Printer was unable to sense the
HDP Film properly while printing.
If this appears as an error, see the
the
Resolving the Film Sensor
errors procedure in Section 2,
page 93.
Flipper
Alignment Unable to align flipper. See the Resolving the Flipper
Alignment Error Message
procedure in Section 2, page 72.
FPGA An unexpected hardware error has
occurred. See the Resolving the FPGA Error
procedure in Section 8, page 439.
FPGA Load
Fail Indicates an unexpected hardware
error has occurred. See the Resolving the FPGA Error
procedure in Section 8, page 439.
Continued on the next page