H3C Technologies H3C Intelligent Management Center - Manual (Page 97)

88
5. Click Reset to clear the query criteria and display all test devices.
Adding a test device
1. Click the Service tab.
2. Select Voice Service Manager > VoIP QoS Evaluation > Test Device from the navigation tree.
3. Click Add in the Test Device List area.
4. Configure the following parameters on the Add Test Device page:
{
Device—Click Select a Device to the right of the Device field. Select a device by using either the
By View or Advanced query option.
{
Start IP Address—Enter the start IP address of the network segment for the connected IP phones.
{
End IP Address—Enter the end IP address of the network segment for the connected IP phones.
{
Configured Network Segment Address—Click Add to add the defined IP segment to this field.
You can add multiple IP segments.
5. Click OK.
NOTE:
The device you add must run the H3C Network Quality Analyzer (NQA) protocol.
Deleting test devices
1. Click the Service tab.
2. Select Voice Service Manager > VoIP QoS Evaluation > Test Device from the navigation tree.
3. Select one or more devices from the Test Device List.
4. Click Delete.
A confirmation dialog box appears.
5. Click OK to confirm your operation.
Managing test tunnels
A test tunnel refers to the tunnel between two test devices.
This function allows you to view the test tunnel list and to query, add, and delete the test tunnels in a VoIP
network.
Viewing test tunnels
1. Click the Service tab.
2. Select Voice Service Manager > VoIP QoS Evaluation > Test Tunnels from the navigation tree.
Test Tunnels list contents
{
Source Device—Label of the source device for the test tunnel.
{
Source Device Type—Type of the source device.
{
Source IP—IP address of the source device.