FEC DSP1500 (SAN3) - Manual (Page 97)

PAGE ６－35
enFORCE Operation Manual
ƒ 1 Step Operation
Performs the series of operations without stopping.
Distance value is counted from [16: SNUG Load] and, it will stop counting if it is less
than SNUG Load.
[16: SNUG Load] is automatically set to 0 for other control methods.
1 Step Operation (using Distance Control)
The distance value will not be counted if the SNUG load is low.
When the standard distance is 90mm:
ƒ 1 Step Operation - SNUG Load Distance Count
After detecting SNUG Load, distance value is counted whatever the load is.
When the standard distance is 90mm:
Chapter 6: System Operation
SNUG Load
50mm 40mm
SNUG Load
90mm
Operation Steps