FEC DSP1500 (SAN3) - Manual (Page 73)

PAGE ６－11
enFORCE Operation Manual
6.3.5 Press Result Display Mode
The following is displayed on the screen in the Press Result Display Mode.
The [D-NO] changes by pressing the [↑] and [↓] buttons.
D-NO DATA UNIT
＿０ Peak Load Value（Judgment Load Value） KN
＿１ Final Distance Value mm
＿２ １ ST Load Rate Value KN/mm
＿３ ２ ND Load Rate Value KN/mm
＿４ １ ST Field Operating Time Sec
＿５ Final Field Operating Time Sec
＿６ Cycle Time Sec
＿７ Operating Mode Number
－０ Operating Method Number
－１ Step
－２ （Monitor）not used
－３ Self Check ON: performed OFF: not performed
－４ Inversion Plug ON: inverted OFF: not inverted
－５
Cause of press stop 0: Reset／No Data／After hand operated,
1: Abnormal 2: BYPASS signal 3: STOP signal
4: REJECT 5: ACCEPT（normal）
－６ Load Judgment Ｌｄ Ｈ／Ｌ
－７ Distance Judgment ｄＳ Ｈ／Ｌ
－８ Load Rate Judgment ｒｔ H / L(1 ST , 1 ST ZONE) H / L(2 ND )
－９ Time Judgment Γｉ Ｈ／Ｌ（1 ST
） Ｈ／Ｌ（ＦＮＬ）
＝０ 1 ST Load Rate Area Increment Load KN
＝１ 2 ND Load Rate Area Increment Load KN
＝２ 1 ST Final Load KN
＝３ 1 ST Peak Load KN
＝４ Final Load Value KN
＝５ Distance at Peak Load (judge load） mm
「
D-NO」 「DATA」
Peak load value
Final Distance value
1ST Load Rate
Distance at Peak Load
Chapter 6: System Operation
D-NO ： left side figure
０
１
２
５
[↑] / [↓]
buttons