I/o recommended connecting circuit – FEC DSP1500 (SAN3) User Manual
Page 43
PAGE ４－11
enFORCE
Operation Manual
4.7.2 Input and Output Ｈ／Ｗ Recommended Connecting Circuit
*See “4.7.4 Synchronization” for SYNC signal connections.
All
enFORCE
inputs and outputs are active true low. All interface devices must
accommodate active true low connection (NPN) for correct operation.
When an input card with high input resistance is used, it may not normally receive OUT
DATA signals depending on the external environment and other conditions.
Note that when Mitsubishi I/O composite cards #A1SH42 and #A1SZ42 are used, the
above mentioned trouble may occur.
Ｉ／Ｏ
Connector
Chapter 4: System Setup and Wiring
See also other documents in the category FEC Accessories for electrical:
- AFC1500 (4 pages)
- AFC1500 (14 pages)
- AFC1500 (20 pages)
- AFC1500 (2 pages)
- AFC1500 (63 pages)
- AFC1500 (83 pages)
- AFC1500 (129 pages)
- AFC1500 (198 pages)
- AFC1200 (6 pages)
- AFC1200 (8 pages)
- AFC1200 (12 pages)
- AFC1200 (5 pages)
- AFC1200 (22 pages)
- AFC1200 (34 pages)
- AFC1200 (16 pages)
- AFC1200 (9 pages)
- AFC1200 (13 pages)
- AFC1200 (4 pages)
- AFC1200 (23 pages)
- AFC1200 (42 pages)
- AFC1200 (10 pages)
- AFC1200 (33 pages)
- AFC1200 (14 pages)
- AFC1200 (24 pages)
- AFC1200 (93 pages)
- AFC1200 (30 pages)
- AFC1200 (90 pages)
- AFC1150 (4 pages)
- AFC1150 (10 pages)
- AFC1150 (18 pages)
- AFC1150 (6 pages)
- AFC1100 (7 pages)
- AFC1100 (9 pages)
- AFC1100 (4 pages)
- AFC1100 (13 pages)
- AFC1100 (21 pages)
- AFC1100 (8 pages)
- AFC1100 (28 pages)
- AFC1100 (18 pages)
- MICRO NR (118 pages)
- FUSIONE-HS-2 (183 pages)
- DSP1500 (SAN3) (6 pages)
- DSP1500 (SAN3) (10 pages)
- DSP1500 (SAN3) (8 pages)
- DSP1500 (SAN3) (26 pages)