FEC DSP1500 (SAN3) - Manual (Page 101)

PAGE ６－39
enFORCE Operation Manual
¾ Data Number 13 - Standard Load
ƒ In Load Control Methods, this is the target load value.
(Example: If Standard Load is 10KN, press will attempt to operate until 10KN is
achieved.)
A setting is possible from 0 to 105% of full-scale value.
¾ Data Number 14 - Speed Change Load
ƒ The load value at which press speed will change to [53: Load Speed].
A setting is possible from 0 to 105% of full-scale value.
If Speed Change Load is detected, even if it has not reached the free run distance, the
speed will change to Load Speed.
Chapter 6: System Operation
Speed
[20]
Freerun Distance
[54]
Recovery
Time
[50] Initial Speed
[42] Crossover Distance
Or
[14] Speed Change Load
[40]
Initial Time
[22]
Standard
Distance
Or
[13] Load
[53] Load Speed
[52] Slowdown
Speed
[41] Freerun
Speed
[53] Return Speed
Time/
Distance
Speed
[14]
Speed Change Load
[54]
Recovery
Time
[50] Initial Speed
[20] Freerun Distance [40]
Initial Time
[22]
Standard
Distance
Or
[13] Load
[53] Load Speed
[41] Freerun
Speed
[53] Return Speed
Time/
Distance