FEC DSP1500 (SAN3) - Manual (Page 71)

PAGE ６－9
enFORCE Operation Manual
6.3.3 RUN Status Key Operation
Selecting [Real Time Display Mode], [Press Result Display Mode] and [Parameter Display Mode]
is possible by pressing the [MODE] button. When the press is operating, the [Press Condition
Display] is displayed.
[Status Display] will be displayed when abnormalities occur or when the STOP or Limit signals are
OFF.
The following diagram shows how to change the display with the [MODE] button.
Chapter 6: System Operation
Real Time
Display Mode
Parameter
Display Mode
Press Result
Display Mode
Operating Condition
Display
Power ON
Press Start Press Finish
[MODE]
[MODE] [MODE]
D-NO
１ figure
D-NO
2 figure
D-NO
Left side fig
D-NO
in: initial
Fr: Free Run
SL: Slow Down
Ld : Load
S d
Real Time
Display Mode
Press Result
Display Mode
Status
Display
D-NO
１ figure
D-NO
Left side fig
Abnormal or STOP / Limit signal OFF
DATA
Abn/STOP
Parameter
Display Mode
D-NO
2 figure
[MODE]
[MODE]
[MODE] [MODE]
D-NO
In: Initial
Fr: Free Run
SL: Slow Down
Ld : Load
ru : Return
d’ : Recovery