Sanyo DSR-M814 - Manual (Page 19)

18
RECORDING
OPERATION
When the alarm duration time (default setting: 20 seconds)
ends, “AL” disappears from the operation display, the
ALARM indicator stops flashing, and recording stops.
z When the hard disk’s remaining space for recording
reaches zero, the FULL indicator lights and recording
stops. You can start recording from the beginning again
by changing the recording setting. ( P.44)
z Alarm recording is taken at the [PICTURE QUALITY]
setting made in [3.RECORDER MENU]>[1.REC MODE
SET]. ( P.43)
The following restrictions apply to alarm recording.
(1) After recording starts (Standby →REC/STOP indicator
lights).
(2) After making “PICTURE QUALITY” or “AUDIO
RECORDING” menu settings and returning to the
camera screen.
For (1) and (2):
z Alarm input is not recognized for a maximum of 4
seconds. Alarm input after the 4 seconds are
recognized as usual.
z Recording does not start for a maximum of 6
seconds regardless of alarm input.
(3) After recording finishes (the REC/STOP indicator turns
off).
z Alarm input is not recognized for a maximum of 5
seconds. Alarm input after the 5 seconds are
recognized as usual.
z Recording does not start for a maximum of 10
seconds regardless of alarm input.
Ending alarm recording
e00_VDH_M814.book Page 18 Thursday, October 28, 2004 9:59 AM