HP 3162 - Manual (Page 50)

Configuration
4-8 3162-A2-GB20-40 August 2000
Configuring DS0 Channels
The DSU/CSU provides Cross Connect configuration options that allow you to do
the following:
H
Display the DS0 assignments for the network, DTE Drop/Insert (DSX-1), and
data port interfaces.
H Allocate DS0 channels on the DTE Drop/Insert (DSX-1) interface to the
network interface.
H
Allocate DS0 channels on the network or DTE Drop/Insert (DSX-1) interface
to particular data ports.
H
Map data from one port to another.
H
Clear (deallocate) all DS0 channels from the network, DTE Drop/Insert
(DSX-1), or data port interface.
To allocate DS0 channels, begin by defining the logical channel configuration for
the network interface, and then the DTE Drop/Insert (DSX-1) interface, and then
any ports, if desired. See
Figure 4-4 for an example of a conceptual diagram of a
channel configuration.
Blank configuration worksheets are provided at the back of Appendix C,
Configuration Options . These worksheets will help you prepare to perform the
procedures in this section. Figure 4-5 and Figure 4-6 are provided as an example
only. See Appendix C for other useful worksheets.
NOTE:
The procedures in this section are examples only. Screen displays may vary
depending on the configuration of the DSU/CSU. For example, the DTE
Drop/Insert (DSX-1) interface is not displayed if this interface is disabled.