High End Systems Technobeam - Manual (Page 91)

3-22 Menu Options Technobeam
®
User Manual
Note The self tests will run continuously until you press the
Placing the Fixture in Setup Mode (S/UP)
This menu item allows you to place the fixture in setup mode so that
you can mechanically home your fixture. If the fixture is out of home
(i.e., the iris or dim flags lose position), will emit an unusually loud
clicking noise when strobing or electronically homing. For more
information on how to mechanically home the fixture, contact High
End Systems customer service.
To place the fixture in setup mode:
1. Press and hold the
2. Using the and arrow buttons, scroll to the “TEST” menu
and press the button to select the “TEST” menu.
3. Using the and arrow buttons, scroll to the “S/UP” option
and press the button to select the “S/UP” option.
4. When the LED displays “SET NOW,” mechanically home the fixture.
5. After mechanically homing the fixture, press any button. This causes
the fixture to electronically home.
Testing the LED Display (DISP)
To perform a self-test on the alphanumeric LED display:
1. Press and hold the
2. Using the and arrow buttons, scroll to the “TEST” menu
and press the button to select the “TEST” menu.
3. Using the and arrow buttons, scroll to the “DISP” option
and press the button to select the “DISP” option. The LED will
run through its self test.
4. Press the
Note The self test will run continuously until you press the
Information Menu (INFO)
The Information menu allows you to view current fixture information
such as internal temperature, lamp hours, total fixture hours, lamp
strikes, software version, DMX errors, sensor information, and DMX
data for any other device on the link. You can also reset the lamp