HP 3000CP - Manual (Page 291)

Front-Panel Messages
Message Explanations and Actions
12-9
Mixed ink system
❏■■■→ At power-on or after the ink systems have been serviced, the printer has detected
components of different ink system types (for example, Imaging and UV Pigmented).
Printing will be disabled until the ink systems are all of the same type. The flashing
squares indicate which ink systems need checking. The error may be because
the
printhead, printhead cleaner and ink cartridge within an ink system are not all of
the same type (UV Pigmented or Imaging) or that entire ink systems are of
different types.
Press
↓ to continue, to check the ink systems. See 11-38, Checking Ink Systems.
MIXED INK SYSTEM
88xxxx
The printer has earlier detected components of different ink system types (for
example, Imaging and UV Pigmented). Printing will be disabled until the ink systems
are all of the same type. The error code “88xxxx” indicates a mixed ink system error.
Press the Replace Ink System key to replace the erroneous ink systems in order to
print with your printer again.
You can press the Enter key to access the main
front-panel menu.
See 11-38, Checking Ink Systems.
Open left door to
access ink cartrg. You are doing an ink system replacement.
Open the left door to access the ink cartridges.
Open right door to
access head cleaners You are doing an ink system replacement.
Open the right door to access the printhead cleaners.
Open window to
access printheads You are doing an ink system replacement.
Open the window to access the printheads.
Out of Ink
■■■❏ → The printer has detected that the amount of ink in the ink systems indicated by
one or more flashing squares, is below acceptable limits for satisfactory printing.
Press
↓ to check the indicated ink systems. See 11-38, Checking Ink Systems. You will
be prompted to change the kit or to ignore the error and continue printing. If there is
still a large amount of ink remaining in the ink cartridges, see
the message
Printhead failure on page 12-12 .
Out of memory
Data was lost The current file is too large for the printer’s memory; the printer has run out of disk
space for processing the file.
To print files of this size, you may need to install more memory to your printer.
Press ENTER when
done The printer is waiting for you to confirm an action or selection.
When you have taken the appropriate action press the Enter key.
Message Explanation and Action