HP 3000CP - Manual (Page 124)

Working with Ink Systems
Removing and Storing Partially Used Ink Systems
4-24
Removing and Storing Partially Used Ink Systems
If you need to print several images unattended (for example, when printing
overnight) and one or more of the ink colors is low on ink, you may want to replace
these colors with new ones before starting to print and store them in the HP
DesignJet CP Ink System Storage Container.
If you need to change from the HP DesignJet CP Ink System (Imaging ink) to the
HP DesignJet CP Ink System UV (UV Pigmented ink) or vice versa, you will need
to store the printheads and printhead cleaners that you are not using. When storing
Ink Systems remember:
CAUTION Do not touch the printhead nozzles.
Handle the Ink Systems with Care
■ Always store the partially used printheads and printhead cleaners in the HP
DesignJet CP Ink System Storage Container. Keep the partially used ink
cartridges close by the HP DesignJet CP Ink System Storage Container. This will
prevent unintentional mixing of different sets of ink system components.
■ You can store the HP DesignJet CP Ink System UV (UV Pigmented ink)
printheads and printhead cleaners in the storage container for up to six weeks
without affecting the Outdoor Durability Warranty (providing you comply with
the warranty procedures).
■ Make sure all four ink colors that you are storing are the same type of HP Ink
System. Never mix UV Pigmented ink and Imaging ink components.
■ Always handle and store the printhead cleaners upright to avoid spilling ink.
■ Handle the system with care.