HP 3000CP - Manual (Page 123)

Working with Ink Systems
After replacing the Ink System
4-23
After replacing the Ink System
After you replace the ink system, the printer:
■ aligns the printheads
■ performs a printhead check (if enabled)
■ calibrates the color, if the color calibration function is enabled in the front-panel.
See chapter 9, Controlling Image Quality, for more information on these
functions.
If no media is loaded, the printer will display the message “Load media to align
printheads.” Load media following the directions in chapter 3, Working with
Media. The alignment procedure requires an A2 or C-size media width. An A3 or
B-size cut sheet media can only be accepted if loaded in the landscape position.
When the front panel displays “STATUS Ready”, you are ready to print.
NOTE:Make sure the printer window and the left and right doors are closed after
you replace ink system components. The printer will not print while these are open.
NOTE:If after installing the ink systems you experience problems see page 11-31,
Solving Ink System Problems.