HP 3000CP - Manual (Page 253)

Troubleshooting
Solving Media-Handling Problems
11-29
between prints or nesting sets.
n If you need to cut the media before the ink-drying time has passed or before the
next print begins printing, press Form Feed and Cut key on the front panel.
However if the Take Up Reel is on you will need to perform the unloading
procedure described on page 3-27, Unloading Media from the Take Up Reel.
n Check the ink-drying time and change if necessary (Device setup / Drying time).
The Automatic Cutter does not Work
n If you are using the Take Up Reel, before you can cut the media you must
remove the Media Weight and wind in the media onto the Take Up Core.
n The automatic cutter is activated only when roll media is loaded.
n The automatic cutter may be disabled from the front-panel menu. Go to Device
setup / Cutter menu and check if the cutter is set to on or off; change it if
necessary.
n Your software application may have disabled the automatic cutter. Refer to your
software documentation or contact your software vendor for more information.