HP 9000 V2600 SCA - Manual (Page 98)

76 Chapter 5
Configuration utilities
ts_config
Figure 26 ts_config showing node 0 highlighted
Notice that after the node has been highlighted that ts_config displays
information concerning the node. In this step, it tells the user what
action to take next, “This node’s JTAG firmware must be upgraded.
Select “Actions,” “Upgrade JTAG firmware” and “Yes” to upgrade.”
Step 2. Select “Actions” to drop the pop-down menu and then click “Upgrade
JTAG firmware,” as shown in Figure 27.
Figure 27 ts_config “Upgrade JTAG firmware” selection.
Step 3. A message panel appears as the one shown in Figure 28. Read the
message. If this is the desired action, click “Yes” to begin the upgrade.