HP 9000 V2600 SCA - Manual (Page 86)

64 Chapter 4
Firmware (OBP and PDC)
HP mode boot menu
HP mode boot menu
In some instances, the boot menu displays; otherwise the operating
system boots and the system is ready for use. The boot menu displays
when one of the following occurs:
• The system encounters a problem while booting
• Autoboot is disabled
• The operator interrupts the boot process
Command Description
------- -----------
AUto [BOot|SEArch|Force ON|OFF] Display or set the specified flag
BOot [PRI|ALT| ] Boot from a specified path
BootTimer [time] Display or set boot delay time
CLEARPIM Clear PIM storage
CPUconfig [] [ON|OFF|SHOW] (De)Configure/Show Processor
DEfault Set the system to defined values
DIsplay Display this menu
ForthMode Switch to the Forth OBP interface
IO List the I/O devices in the system
LS [|flash] List the boot or flash volume
PASSword Set the Forth password
PAth [PRI|ALT|CON] [] Display or modify a path
PDT [CLEAR|DEBUG] Display/clear Non-Volatile PDT state
PIM_info [cpu#] [HPMC|TOC|LPMC] Display PIM of current or any CPU
RemoteCommand node# command Execute command on a remote node
RESET [hard|debug] Force a reset of the system
RESTrict [ON|OFF] Display/Select restricted access to Forth
SCSI [INIT|RATE] [bus slot val] List/Set SCSI controller parms
SEArch [] Search for boot devices
SECure [ON|OFF] Display or set secure boot mode
TIme [cn:yr:mo:dy:hr:mn[:ss]] Display or set the real-time clock
VErsion Display the firmware versions
[0] Command:
At this point, the user can either enter any command on the menu or
continue the boot process. To continue booting, enter the following
command:
Command: boot
Commands and options are case-insensitive (auto = AUTO). Each
command has a shortcut, which is the minimum letters that can be
entered to execute the command. For example, to execute the search
command, enter
SEA , SEAR , SEARC , or SEARCH . This shortcut is
indicated by capital letters in Table 10 and in the rest of this chapter.