HP 9000 V2600 SCA - Manual (Page 150)

128 Chapter 6
HP-UX Operating System
Starting HP-UX
Table 14 Boot variables
Reviewing the state of the file system
During the start-up process, the /sbin/bcheckrc script executes
/usr/sbin/fsclean . This command determines the shut down status
of the system and returns three possibilities:
1. Proper file system shut down
The startup process continues, and the following message is
displayed:
/usr/sbin/fsclean:/dev/dsk/0s0(root device) ok file system is OK, not running
fsck
2. Improper file system shut down
Variable Description
AUto BOot [ON|OFF ] If set to ON , the server automatically boots HP-
UX from the primary ( PRI ) device during system
startup or reset. When set to OFF the server boots
to the OBP menu interface.
AUto SEArch [ ON | OFF ] If set to ON , the server searches for and lists all
bootable I/O devices.
AUto Force [ ON | OFF ] If set to ON , then OBP allows HP-UX to boot even
if one or more cabinets does not complete power
on self test. When set to
OFF , all cabinets must
successfully pass power on self test for OBP to
permit the server to boot HP-UX.
BootTimer [ seconds ] Sets the number of seconds for the system to wait
before booting. This is used to allow external
mass storage devices to come online.
PAth [PRI|ALT|CON][ path ] Displays and sets primary, alternate, and console
hardware paths. Keyboard path is displayed but
cannot be modified.
SECure [ON|OFF] If set to ON, enables secure boot mode. If set, the
boot process cannot be interrupted. Only useful if
autoboot is ON; the system will autosearch and
autoboot.