HP 9000 V2600 SCA - Manual (Page 75)

Chapter 3 53
SSP operation
Using the console
prompting the user if only one complex is configured). This utility
accesses the desired node based on node ID. However, the single node
must still be configured by
ts_config and assigned a complex name
before it can be accessed.
Targeting commands to nodes
Use the jf-ccmd_info command to determine what names or IP
addresses the JTAG interfaces have been set to on an SPP. The command
provides a list with the following information:
• Ethernet Address (MAC)
• IP Address
• Complex Serial Number
• Node Number
• Environmental LED’s
• Power Status
• SCUB Status
• Diagnostic (JTAG) node names
The diagnostic node name or the JTAG IP address is required when
using the
load_eprom command. Since the SSP software allows
changing the default JTAG hostnames and IP addresses, the user may
need to run this command to view the unique names and active IP
addresses for JTAG.
Example:
load_eprom -n COMPLEX_NAME-0000 -l /spp/firmware/diaglifhdr.fw