HP 8000M - Manual (Page 230)

7-2
Monitoring and Analyzing Switch Operation
Status and Counters Screens
M
oni
to
ri
n
g
and
An
al
yz
in
g
Sw
itc
h
Op
e
ra
tio
n
Status and Counters Screens
This section describes the status and counters screens available through the
switch console interface and/or the web browser interface.
N o t e You can access all console screens from the web browser interface via Telnet
to the console. See “Configuration Tab” on page 3-24.
Status or Counters Type Interface Purpose Page
General System Information Console Lists switch-level operating information. 7-5
Management Address
Information Console Lists the MAC address, IP address, and IPX network number for
each VLAN or, if no VLANs are configured, for the switch. 7-6
Module Information Console For each slot, lists the module type (such as 10/100TX) and
description. 7-7
Port Status Overview Browser Shows port utilization and the Alert Log. 3-14
Port Status Console/
Browser Displays the operational status of each port. 7-8
Port Counters Console/
Browser Summarizes port activity. 7-10
Address Table
(Address Forwarding Table) Console Lists the MAC addresses of nodes the switch has detected on the
network, with the corresponding switch port. 7-14
Port Address Table Console Lists the MAC addresses that the switch has learned from the
selected port. 7-15
Spanning Tree Information Console Lists Spanning Tree data for the switch and for individual ports. If
VLANs are configured, reports on a per-VLAN basis. 7-17
IP Multicast (IGMP) Status Console Lists IGMP groups, reports, queries, and port on which querier is
located. 7-19
Automatic Broadcast
Control (ABC) Information Console If VLANs are configured, reports are on a per-VLAN basis. 7-21
Switch Mesh Information Console For meshed ports, describes operating state, MAC address of
adjacent meshed switch, and identity of peer port on adjacent
switch. 7-22
VLAN Information Console For each VLAN configured in the switch, lists 802.1Q VLAN ID and
up/down status. 7-23