HP 8000M - Manual (Page 162)

6-86
Configuring the Switch
Load Balancing: Switch Meshing
C
o
n
fig
u
rin
g
th
e
Sw
itc
h
Figure 6-57. Example of Mesh Group Assignments for Several Ports
6. When you are finished assigning ports to the switch mesh, press [Enter],
then [S] (for Save) and return to the Main Menu.
N o t e For meshed ports, leave the “Type” setting blank. (Meshed ports do not accept
a Type setting.)
7. To activate the mesh assignment(s) from the Main Menu, reboot the
switch by pressing the following keys:
a. [6] (for Reboot Switch)
b. Space bar
c. [Enter]
(The switch cannot dynamically reconfigure ports to enable or disable
meshing, so it is always necessary to reboot the switch after adding or
deleting a port in the switch mesh.)