HP 8000M - Manual (Page 116)

6-40
Configuring the Switch
Spanning Tree Protocol (STP)
C
o
n
fig
u
rin
g
th
e
Sw
itc
h
Enabling STP from the Web Browser Interface
This procedure enables or disables STP on the switch.
Figure 6-28. Configuring STP from the Web Browser Interface
1. Click Here
2. Click Here
3. To enable or disable STP, click on the drop-down
menu, then click on your selection (On or Off).
4. Click on Apply Changes to activate your choice.
Parameter Description
Spanning Tree
Default: Off
Enables or disables Spanning Tree Protocol across all ports on the
switch, including those in separate VLANs. Other STP parameters are
available through the console interface. Enabling or disabling STP
through the web browser interface does not affect the settings of these
other parameters. For more information on STP operation, refer to “How
STP Operates” on page 6-42.