Blackmagic Design DeckLink Studio 4K Capture & Playback Card - Manual (Page 32)

Using your Favorite 3rd Party Software 32
To output a live video signal:
Step 1.
Select File>Output to VTR.
Step 2. Select the clip(s) to output from the Media Library. You can also select a folder to output its
contents. The VTR Output module appears.
Step 3. From the VTR Device box, select Live NTSC or Live PAL.
The Start Mode box is unavailable. With Live Video output, you must use Start On Pen mode. You can use
Stop On Pen or Stop On Frames to end the output.
Step 4. Set output options. For example, enter the clip name and enable the video tracks and audio
channels that you want to capture.
Step 5. On the device receiving the signal, start the recording, or take any action required to enable the
reception of the signal from Autodesk Smoke.
Step 6. Select Process to begin the output on Autodesk Smoke.
Step 7. Click anywhere on the screen to end the output in Stop On Pen mode.
Use Start On Pen mode when outputting live video.
Select Live PAL or Live NTSC when outputting a live video signal.