PLANET WGSW-5242 - Manual (Page 22)

User’s Manual of WGSW-5242
22
Appendix A
The section contains cable information of the Managed Switch.
1.4 Product Features

Physical Port
 48-Port 10/100Base-TX Fast Ethernet RJ-45
 4-Port 10/100/1000Base-T Gigabit Ethernet RJ-45
 2 100/1000Base-X mini-GBIC/SFP slots, shared with Port-51 and Port-52
 RS-232 DB9 console interface for Switch basic management and setup

Layer 2 Features
 Complies with the IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet standards
 Supports Auto-Negotiation and Half-Duplex / Full-Duplex modes for all 10Base-T/100Base-TX and 1000Base-T ports
 Auto-MDI/MDI-X detection on each RJ-45 port
 Prevents packet loss Flow Control
- IEEE 802.3x PAUSE Frame flow control for Full-Duplex mode
- Back-Pressure Flow Control in Half-Duplex mode
 High performance Store and Forward architecture, broadcast storm control, runt/CRC filtering eliminate erroneous
packets to optimize the network bandwidth
 8K MAC address table, automatic source address learning and ageing
 4Mbit embedded memory for packet buffers
 Supports VLAN
- IEEE 802.1Q Tag-Based VLAN
- GVRP for dynamic VLAN Management
- Up to 256 VLANs groups, out of 4096 VLAN IDs
- Private VLAN Edge (PVE) supported
- Management VLAN
 Supports Link Aggregation
− up to 6 trunk groups
− up to 8 ports per trunk group with 1.6Gbps bandwidth (Full Duplex Mode / Fast Ethernet port)
− up to 4 ports per trunk group with 8Gbps bandwidth (Full Duplex Mode / Gigabit Ethernet port)
− IEEE 802.3ad LACP (Link Aggregation Control Protocol)
 Spanning Tree Protocol
- STP, IEEE 802.1D (Classic Spanning Tree Protocol)
- RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)
- MSTP, IEEE 802.1s (Multiple Spanning Tree Protocol, spanning tree by VLAN)
 Port Mirroring to monitor the incoming or outgoing traffic on a particular port (many to one)

Quality of Service
 4 priority queues on all Switch ports
 Traffic classification
- IEEE 802.1p CoS
- IP TOS / DSCP / IP Precedence
- Port-Based QoS
 Supports QoS and In/Out bandwidth control on each port