PLANET WGSW-5242 - Manual (Page 172)

User’s Manual of WGSW-5242
172
To have access to the full suite of commands, the operator must enter the Privileged Mode. Enter “enable” to into the Privileged
Mode and it requires password authentication. From Privileged Mode, the operator can issue any Exec command to enter the
Global Configuration mode.
Command> enable
Username: admin
Password: admin
1. For security reason, please change and memorize the new password after this first setup.
2. Only accept command in lowercase letter under console interface.
Configure IP address
The WGSW Managed Switch is shipped with default IP address as following.
IP Address : 192.168.0.100
Subnet Mask : 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please use the procedures as follow:
 Show the current IP address
1. On ”Switch# ” prompt, enter “show network”.
2. The screen displays the current IP address, Subnet Mask and Gateway. As show in Figure 5-2 .
Figure 5-2
Show IP information screen