PLANET WGSW-5242 - Manual (Page 132)

User’s Manual of WGSW-5242
132
(5-3600 sec)
Range: 5-3600 seconds;
Default: 5 seconds
This parameter only applies to SNMP applications which use data stored in the
LLDP MIB for network monitoring or management. Information about changes in LLDP
neighbors that occur between SNMP notifications is not transmitted. Only state changes
that exist at the time of a notification are included in the transmission. An SNMP agent
should therefore periodically check the value of lldpStatsRemTableLastChangeTime to
detect any lldpRemTablesChange notification-events missed due to throttling or
transmission loss.
• Fast Start Count (1-10) Configures the amount of LLDP MED Fast Start LLDPDUs to transmit during the activation
process of the LLDP-MED Fast Start mechanisim.
Range: 1-10 packets;
Default: 4 packets
The MED Fast Start Count parameter is part of the timer which ensures that the
LLDP-MED Fast Start mechanism is active for the port. LLDP-MED Fast Start is critical to
the timely startup of LLDP, and therefore integral to the rapid availability of Emergency
Call Service.
• Management Address
Transmit Ports
Specifies the LLDP port members.
4.10.2 LLDP Statistics
This page provides an overview of all LLDP traffic. Two types of counters are shown. Global counters are counters that refer to
the Managed Switch, while local counters refers to counters for the currently selected switch. The LLDP Statistics screen in
Figure 4-10-3 appears.