Figure 33 top access panel – Emerson Series 600T User Manual

Page 42

Installation

The AC wire is field-supplied. Wire size and installation must comply with all applicable local,

regional and national regulations (e.g., National Electric Code for USA). An 18 AWG cable (approxi-

mate metric equivalent: 0.82mm

wire section) is recommended for this connection.

Figure 32 shows the auxiliary power fused disconnect and terminals 1, 2 and 3, the landing points

for the AC wire on the Liebert FS side. Open the circuit while wiring, check the fuses and close after-

wards when ready to test or start up Liebert FS.

Figure 32 Auxiliary power fused disconnect with connection points for AC wire

The AC wire should be pulled from the left (top access recommended) and through the rear top access

panel (see Figure 33). Run the AC wire along the underside of the top cabinet frame rail from the

rear to the front of the cabinet. Terminate the AC wire at the fused disconnect (pictured in Figure 32;