Emerson Series 600T - Manual (Page 37)

Installation
25
4.1.3 Raised Floor Mounting
Raised Floor Mounting Kit
Liebert has included a complete anchoring kit with each Liebert FS for surface mounting. The kit is
intended to securely fasten the Liebert FS to its location for operational safety and seismic requirements.
The anchoring kit includes:
• One floor mounting template, Figure 149
• 2 cabinet mounting brackets
• 4 drop-in hex flange bolts, each 1/2" diameter, 3" long (12.7mm, 76.mm)
• 4 washers (1/2" hole and 2" outer diameter) for hex flange bolts
• 4 lock washers for hex flange bolts
• 4 nuts for hex flange bolts, each 1/2" (12.7mm)
• 4 hex bolts, each 1/2" diameter, 3/4" long (12.7mm diameter, 20mm long) retained from shipping
package (see 3.2.2 - Unpacking)
Raised Floor Mounting Tools
The following tools are needed for the cabinet raised floor mounting:
• Electric drill with 1/2" (12.7mm) minimum chuck size
• 5/8" (16mm) drill bit
• Drill bit—used for pilot hole—for example, 1/8" (3.2mm) diameter
• 3/4" (19mm) combination wrench
• 18mm combination wrench
Raised Floor Mounting Instructions
To mount the Liebert FS cabinet on the floor:
1. Prepare a clean, level finished surface, free of obstructions, for installation of mounting kit.
2. Tape the floor mounting template (see Figure 149) to installation location, pre-drill a pilot hole,
then remove paper and continue with 5/8" (16mm) drill bit.
3. Match mounting brackets with holes under base of cabinet (see Figure 21). Make sure that the
bracket holes align with the mounting spots on the underside of the cabinet and secure brackets
with the four 1/2" diameter x 3/4" long (12.7mm diameter x 20mm long) hex bolts retained from
the shipping package. The bolts must be tightened to 40 foot-pounds (54 N-m) of torque.
4. Position and align cabinet and bracket slots with the newly drilled holes (see Figure 22).
5. Insert four drop-in hex flange bolts through bracket mounted at front and rear of cabinet (see
Figure 23).
Figure 25 Raised floor mounting
2"
(50mm) dia.
1/2" (12.7mm)
dia. steel bolt
Large diameter washer
Lockwasher
Raised
floor