Emerson Series 600T - Manual (Page 64)

Operation
52
6.0 O
PERATION
6.1 Operator Controls
The Liebert FS uses a Control Panel as the primary means for an operator to interface with the sys-
tem. The Control Panel enables the operator to perform the following tasks:
Initial setup and adjustments to programmable parameters (access limited by Security
Access function):
• Set the Liebert FS Control Parameters
• Configure Liebert FS for operation with external equipment
Initial setup and adjustments to Security Access functions
• Set pass codes and access levels
Execute operational procedures:
• Startup and shutdown of the Liebert FS.
Quick view of operational status:
• View current Mode of Operation
• View current Status
Access System Status reports:
• Check temperatures and voltages
• Check vital system health indicators
Access System History
• Check number of discharges
• Check for total hours of operation
• Check for warnings and faults history
Monitor the power flow between the Liebert FS and a UPS and other Liebert FS meter
readings:
• Monitor power flow from Liebert FS to the UPS DC Bus or from UPS to the Liebert FS
• Monitor Liebert FS State of Charge
• Monitor DC Bus Voltage
• Determine if the critical load is being supplied power from the Liebert FS
• Monitor charging after discharge