Emerson Series 600T - Manual (Page 112)

Data Collection Module
100
A
PPENDIX
B.0D
ATA
C
OLLECTION
M
ODULE
Appendix B.1 General Information
Appendix B.1.1 Overview
The Data Collection Module (DCM) is designed to provide real-time data monitoring and data storage
for the Liebert FS. The DCM collects data on virtually every event that occurs in the Liebert FS. Data
such as speed, temperature and voltage are just a few of the data points that the DCM will be collect-
ing and storing on its internal memory card. The DCM has an HTML interface, which means any
Internet browser, such as Internet Explorer or Netscape, is all that is required to access the
Liebert FS data.
Appendix B.1.2 Features
The DCM comes equipped with four (4) RS-232 communication ports and a 10/100 Base-T RJ-45 port.
The DCM runs on the Linux operating system, which resides on the internal compact flash memory
card. Dynamic Host Configuration Protocol (DHCP) has been enabled on the DCM to allow easy inte-
gration with an existing network.
Appendix B.2 DCM Installation and Configuration
Appendix B.2.1 Installation
The DCM has been installed at the front of the Liebert FS inside the door on the service panel and has
been securely mounted adjacent to the AC auxiliary fused disconnect. The power cable and the serial
communication cable have been connected at the factory as seen in Figure 104.
The DCM has been installed on the inside door of the Liebert FS and has been securely mounted adja-
cent to the Control Panel. The power cable and the serial communication cable have been connected
at the factory as seen in Figure 104.
Figure 104 Data Collection Module location, features
DCM Power and
Serial Connections
Fused
Disconnect
Power
Connection
Serial
Connections Ethernet Port