Extron Electronics MLC 104 Plus Series - Manual (Page 184)

Index, cont’d
MLC 104 Plus Series • Index C-4
PRELIMINAR
Y
IR-related settings, SIS commands for
disable IR reception 4-40
IR 402 remote control
overview 1-5
IRCM-DV+
IRCM-DV+ activation (SIS commands) 4-34
IRCMs
definition/description A-10
overview 1-5
IR driver files
using IR learning to create customized drivers 3-12
IR drivers
embedded Web page 3-22
IR learning
distances and angles 2-8, 2-20
frequencies accepted by the MLC 2-8
purpose and software 3-12
receiver/sensor location and use 2-20
IR reception
disable IR reception SIS command 4-40
sensor location, use, reception angle 2-20
IR signal sensor
IR learning receiver 2-8
IR learning sensor location and use 2-20
L
lamp hours 3-16
LAN (IP) connector
cabling, LEDs, and default settings 2-19
LAN port defaults 2-19, 4-2
LEDs
front panel button LED control 4-38
limit audio level on display power-on 4-33
locking and unlocking the front panel 2-7
lockout.
See front panel security lockout (executive
mode)
input switching lockout duration 4-40
low voltage screen motor controller
controlling with an MLC 5-20
M
main event file (0.evt) 1-5, 3-20
miscellaneous settings (SIS commands) 4-39
MLA-VC10
DIP switches 5-26
MLA-VC10 volume controller
using with MLC and amplifier 5-25
MLC-initiated messages 4-2
MLC 104 IP Plus
cut-out template A-13
MLC 104 IP Plus DV+
wiring connections 2-14
MLC 104 IP Plus L 6-10
rack mounting 6-10
MLM 104 6GWP A-17
MLM 104 LAAP A-16
MLS connector
wiring and protocol 2-17
modes, reset 2-22
mounting
electrical box 6-6
Euro Channel 6-11
mud ring 6-6
rack 6-10
UL rack mounting guidelines 6-11
wall or furniture 6-10
moving a button cap 6-3
mud ring
sizes and installation 6-7
mud ring, mounting to 6-6
N
National Electrical Code (NEC) 6-6
P
passwords
MLC’s responses 4-3
prompts from MLC 4-3
requirements for 3-18
Passwords embedded Web page 3-18
personal identification number (PIN)
enable PIN (SIS command) 4-40
pinout guide 2-23
power
wiring the power connector 2-20
projector control 1-3
PWR (power) connector
wiring, polarity, requirements 2-20
Q
query strings 5-36
R
rack mounting 6-10
UL rack mounting guidelines 6-11
reset (zap) commands and erase commands (SIS) 4-32
Reset button
Reset button and LED location 2-21
using to reset the MLC 2-22
reset modes 2-22
resetting the unit
after firmware upgrade B-9
manual reset modes 2-22
reset (zap) commands and erase commands (SIS) 4-32
Reset Device After Firmware Update B-7
resetting the MLC and restoring its configuration after a
firmware update B-9
RS-232 protocol
front panel Config port 4-2