EXP Computer ThinConnect4 - Manual (Page 45)

ThinConnect4 <35>
3. We recommend user to select “Use DHCP Server Function”.
Otherwise, clear the check mark on “Use DHCP Server Function” and click “OK”.
Factory default:
When the ThinConnect4 IP address is set to default (192.168.0.1), the following
parameters will be set to the DHCP Server setting:
• Start IP Address: 192.168.0.2
• Subnet Mask: 255.255.255.0
• Number of Addresses: 32
• Gateway: 192.168.0.1
As for the above default setting, the IP address distribution pool will start from
“192.168.0.2” for a maximum of 32 Ips which ends at “192.168.0.33”. The DHCP
sever can assign any IP address in this range to a PC.
If you are choosing factory default, continue to the next page.
Change DHCP setting:
Do not set the IP address that will overlap the existing address.
• Start IP Address: Start IP address pool assign to PC.
• Subnet Mask: Subnet Mask to assign to PC.
• Number of Addresses: Setting range is from 1 to 32.
• Gateway: This setting should be identical to the IP address for
ThinConnect4