EXP Computer ThinConnect4 - Manual (Page 23)

ThinConnect4 <13>
2.6 Windows 95/98 Settings for LAN Connection
This section applies to all PCs connect to ThinConnect4.
In order to connect to the Internet successfully, all PCs connected to the ThinConnect4 have
to have the TCP/IP protocol installed and set properly.
2.6.1 Verify the TCP/IP protocol installation
To verify if TCP/IP protocol is installed properly, please proceed to the following steps.
Double-click on “My Computer” -> “Control Panel” -> “Network”
In Network window, check if TCP/IP is shown and properly set up.
(The following display shows the TCP/IP protocol is already installed.)
If TCP/IP protocol has properly installed, please proceed to 2.6.3 TCP/IP
Settings (Page 16).
If there is NO TCP/IP protocol show in the “Network” window show above, go to the next
page to install TCP/IP protocol.