Epson Endeavor 468C User Manual

Page 71

If you want your computer to always start at slow speed, you

can change the default setting through SETUP. See Chapter 2

for instructions.

Some copy-protected programs require the computer to run at

slow speed while accessing the program on a diskette. These

programs also usually require you to leave a key disk-the

diskette that contains the copy protection-in the diskette

drive. If you use a copy-protected program, you can change the

speed to slow to access the diskette and return it to fast speed

when you are finished.

You can change the processor speed temporarily by entering

one of the following commands from the numeric keypad on

your keyboard:

To select slow speed, press

To select fast speed, press

(Hold down the key and the key simultaneously

and then press the or key on the numeric keypad.)

Note

You can use the commands listed above while you are

running a program. However, if the program uses one of

these commands for another function, you cannot use it to

change the processor speed. You can, however, enter the

command at the MS-DOS command prompt or change it

through the SETUP program.

The speed setting remains in effect until you reset the

computer, change the speed with a keyboard command, or

change the speed using SETUP.

Using Your Computer

3-19