Epson Endeavor 468C - Manual (Page 123)

5. To insert a diskette drive, align the guiderails on each side of
the drive with the notches on each side of the drive bay and
slide the drive into the bay as far as it will go, as shown
below. Secure the guiderails to the computer case with the
two retaining screws.
notch
guiderail
6. If you are installing a diskette drive in the lower bay, you
need to remove the faceplate on the computer’s front panel
because it covers this bay. Turn the cover over and locate
the faceplate. Remove the screws securing the faceplate to
the inside of the computer’s cover and remove the
faceplate, as shown in the following illustration.
5-20 Installing and Removing Drives