beautypg.com

Saving your settings and exiting setup – Epson Endeavor 468C User Manual

Page 51

background image

Saving Your Settings and Exiting SETUP

When you leave SETUP, you can either save the settings you

have changed or exit the program without saving any changes.

To save your settings, follow these steps:

1. Press to return to the main SETUP menu.

2. Select option 6, SAVE settings and exit, and

press [Enter. You see this message:

Write to CMOS RAM and exit (Y/N)?

3. Press and The system reboots.

4. If you have just run SETUP for the first time, see “Post-SETUP

Procedures,” below.

To exit SETUP without saving the setting, select option 7,

Exit without saving settings. The system reboots with

your original settings.

Note

If your computer detects a problem in your SETUP

configuration, you may see an error message and a prompt

to run SETUP when it is rebooting. Follow the instructions

on the screen to run SETUP and correct the problem.

You may also see an error message when your computer is

rebooting if you have not installed your operating system on

the hard disk and you did not insert a system diskette in

drive A. If you receive this error message, follow the

instructions in your operating system manual to install it.

2-18

Running the SETUP Program