Setting the keyboard options – Epson Endeavor 468C User Manual
Page 46
Four additional shadow options allow you to shadow 32KB at
the memory addresses listed
on
the screen. You may want to
enable one or more of these shadow options if, for example,
you are using option cards that contain ROM. You
can
shadow
the memory on the card to your system’s RAM using these
options. Check the memory map on page A-6 and the
documentation that came with your option card to determine
which addresses your option card can access. You may also
need to set some switches or jumpers on the option card.
Setting the Keyboard Options
There are four options for the keyboard: Test, NumLock,
Key rate, and Key delay. The table below describes the settings
available.
Keyboard options
Option
Test
NumLock
Settings
Enabled’
Disabled
On*
Off
Description
Tests keyboard at power-on
Skips keyboard test at power-on
Determines initial NumLock
status when system is turned on
or reset
Key rate
Key delay
2.0-30.0
(characters per
second)
0.25-1.OO
(seconds)
Sets rate at which a character
repeats when key is held down;
default is 10.9
Sets period of delay between
the time a key is pressed and the
character appears on the
screen; default is 0.50
l
Default setting
Running the SETUP Program
2-13