Epson Endeavor 468C - Manual (Page 103)

3. Replace the three cover retaining screws, as shown below.
4. Reconnect the computer to the monitor, printer, keyboard,
and any other peripheral devices you have. Then reconnect
the power cable to the back of the computer and to an
electrical outlet.
Post -installation Procedures
After you install or remove options such as memory modules
or a new processor, you must run SETUP to update the
computer’s configuration. See Chapter 2 for instructions.
Additionally, you may need to add some commands to your
configuration files. See your operating system manual and the
manual that came with your optional equipment for
instructions.
4-32 Installing and Removing Options