Epson Endeavor 468C User Manual
Page 35
The configuration you define through SETUP is stored in a
special area of memory called CMOS RAM. This memory is
backed up by a battery, so it is not erased when you turn off or
reset the computer.
Whenever you reboot the computer, it checks the settings, and
if it discovers a difference between the information in the
CMOS RAM and its actual hardware configuration, it prompts
you to run SETUP. You see a message describing the error as
well as the following prompt at the bottom of the screen:
Press
run SETUP or
If this happens, press to run SETUP and correct the
setting.
Another SETUP option displays information about your system
board. This information provides a useful reference about
jumper and DIP switch settings, SIMM configuration, and hot
key combinations. See page 2-17 for more information.
SETUP also lets you restore the default values for your
configuration. This is useful if you have made changes but
don’t want to keep them; you can restore all the default
settings. See “Loading Default SETUP Values” on page 2-17.
2-2
Running the SETUP Program